Endress+Hauser Micropilot FMR52 - Measuring Conditions

Installation Micropilot FMR51, FMR52 PROFIBUS PA
24 Endress+Hauser
6.4.3 Horn antenna, flush mount (FMR52)
Alignment
• Align the antenna vertically to the product surface.
The maximum range may be reduced if the horn antenna is not vertically aligned.
• A marking at the flange (somwhere between the flange holes) or the boss enables
alignment of the antenna. This marking must be aligned towards the tank wall as well as
possible.
90°
90°
90°
90°
90°
90°
90°
90°
90°
90°
A
B
A0018974
Depending on the device version the marking may be a circle or two short parallel lines.
Nozzle mounting
H
max
A0016819
 6 Nozzle height for horn antenna, flush mount (FMR52)