Endress+Hauser Micropilot FMR52 - Page 38

Integration into a PROFIBUS network Micropilot FMR51, FMR52 PROFIBUS PA
38 Endress+Hauser
2. The device restarts automatically. The address remains the same as before (factory
setting: 126).
3. Set the required address via the operating menu: "Setup" menu → Device address
2
98
3
4
5 6
7
8
1
DIP
ON
A0015903
 12 Example of software addressing; switch 8 is in position "ON"; the address is defined in the
operating menu (Setup → Device address)