Oil Leak Detector NAR 300 system
Endress+Hauser 7
1.4 Return
The following procedures must be carried out before the Oil Leak Detector NAR 300 system sent
to Endress+Hauser for repair:
• Always enclose a duly completed "Declaration of Contamination" form. Only then can Endress
+Hauser transport, examine and repair a returned device.
• Enclose special handling instructions if necessary, for example, safety data sheet as per EN
91/155/EEC.
• Remove all residue which may be present. Pay special attention to the gasket grooves and crevices
where fluid may be present. This is especially important if the fluid is dangerous to health, e.g.
corrosive, poisonous, carcinogenic, radioactive, etc.
A copy of the “Declaration of Contamination” is included at the end of this operating manual.
Caution!
• No instrument should be sent back for repair without all dangerous material being completely
removed first, e.g. in scratches or diffused through plastic.
• Incomplete cleaning of the instrument may result in waste disposal or cause harm to personnel
(burns, etc.). Any costs arising from this will be charged to the operator of the instrument.
1.5 Disposal
In case of disposal, please separate the different components according to their material consistency.
1.6 Software history
1.7 Contact addresses of Endress+Hauser
The addresses of Endress+Hauser are given on the back cover of this operating manual. If you have
any questions, please do not hesitate to contact your E+H representative.
Software version / Date Software changes Documentation changes
OILEYE CI/ST V. 1.40/11.03 Original software.
1 Safety instruction
To Next Page
Loading...