Endress+Hauser nivotester FTL 325 P - Page 8

8
Accuracy
Settling time/length Final switching status after switching on the power supply: approx. 10...40 s, depending on the
connected measuring sensor.
With Liquiphant M and Liquiphant S (high temperature) note the self-test function of the FEL 57
electronic insert.
Operating conditions (Installation conditions)
Installation instructions Operating location
The Nivotester must be housed in a switch cabinet outside the explosion hazardous area.
A protective housing (IP65) for up to four 1-channel or two 3-channel Nivotesters is available for
outdoor installation.
L00-FTL325Px-11-06-xx-xx-001
Installation position
Vertical on DIN top-hat rail (TS 35 to EN 50022).
L00-FTL325xx-11-06-xx-xx-001
min. IP 65
E
X
E
X
PFM
PFM
Liquiphant FTL
Soliphant FTM
U~
U–
~
CH1
CH2
CH3
FTL 325 P
EN 50022; 35 x 7,5
EN 50222, 35 x 15
[Ex ia]
CH1 CH2
CH3
CH1 CH2 CH3
T
FTL 325