Endress+Hauser NRF81 - Initial Settings

Tankside Monitor NRF81 Commissioning
Endress+Hauser 31
7.1.2 Operation via service interface and FieldCare/DeviceCare
CDI
1
2
3
A0025572
 19 Operation via service interface
1 Service interface (CDI = Endress+Hauser Common Data Interface)
2 Commubox FXA291
3 Computer with "FieldCare" or "DeviceCare" operating tool and "CDI Communication FXA291" COM DTM
7.2 Initial settings
7.2.1 Setting the display language
Setting the display language via the display module
1. While in the standard view (), press "E". If required, select Keylock off from the context
menu and press "E" again.
 The Language appears.
2. Open the Language and select the display language.
Setting the display language via an operating tool (e.g. FieldCare)
1. Navigate to: Setup → Advanced setup → Display → Language
2. Select the display language.
This setting only affects the language on the display module. To set the language in the
operating tool use the language setting functionality of FieldCare or DeviceCare,
respectively.
7.2.2 Setting the real-time clock
Setting the real-time clock via the display module
1. Navigate to: Setup → Advanced setup → Date / time → Set date