Endress+Hauser Promass 300 User Manual

Products Solutions Services
EA001164D/06/A2/01.16
71327830
Alteration Instructions
Promag 300, 500
Promass 300, 500
Activate the Software Licence Code
These Instructions are Alteration Instructions; they
do not replace the Operating Instructions included in
the scope of supply.
For detailed information, refer to the Operating
Instructions and other documentation or visit
"www.endress.com/deviceviewer".

Endress+Hauser Promass 300 Specifications

General

Measuring Principle	Coriolis
Pressure Range	Up to 100 bar
Measured Variables	Mass flow, density, temperature
Output Signal	4-20 mA, pulse, frequency
Max. Process Pressure	100 bar
Ingress Protection	IP66/67
Process Pressure Range	Up to 100 bar
Output Signals	4-20 mA, pulse, frequency
Protection Class	IP66/67
Accuracy	±0.1% of rate
Communication Protocols	HART, PROFIBUS PA, FOUNDATION Fieldbus
Display	4-line backlit display
Power Supply	24 V DC
Device Type	Mass Flow Meter
Process Connection	Flange, threaded, hygienic fittings
Lining	Not applicable
Sensor Material	Stainless steel
Electronics Housing Material	Aluminum, stainless steel
Ambient Temperature	-40 to +60 °C
Process Temperature	-50°C to +150°C
Repeatability	±0.05% o.r.
Process Temperature Range	-50 to +150 °C (-58 to +302 °F)
Housing Material	Aluminum, Stainless steel
Certifications	ATEX, IECEx, NEPSI
Temperature Range	-50°C to +150°C

Summary

Overview Registration Key

Authorized Personnel for Alteration

Authorized Personnel for Nameplate Affixing

Safety Instructions and Precautions

General Safety Guidelines and ESD Protection

Details mandatory safety compliance, handling of energized devices, ESD protection, and use of genuine parts.

Required Tool List

Safety Symbols Explanation

Information Symbols and Codes

Activate Application Package via Software Licence Code

Enter Software Option Code via Device Display

Step-by-step guide to activate software options using the device's display interface.

Enter Software Option Code via Webserver

Instructions for activating software options using the Webserver interface.

Enter Software Option Code via FieldCare

Procedure for activating software options using the FieldCare software tool.

Update Device Data in CER Database

Details on updating device data in the CER database after technical modifications.