What to do if Endress+Hauser Proline Promass I 100 Measuring Instruments device measures incorrectly?
If your Endress+Hauser Measuring Instruments device is measuring incorrectly, first check and correct the parameter configuration. Second, observe the limit values specified in the Technical Data.
Why is the green power LED on the main electronics module of the Endress+Hauser Proline Promass I 100 transmitter dark?
The green power LED on the main electronics module of the Endress+Hauser Measuring Instruments transmitter might be dark because the supply voltage does not match what is specified on the nameplate. To fix this, apply the correct supply voltage. Another cause could be that the power supply cable is connected incorrectly, so check the terminal assignment.
How to fix a dark green power LED on Safety Barrier Promass 100 Endress+Hauser Proline Promass I 100?
A dark green power LED on the Safety Barrier Promass 100 Endress+Hauser Measuring Instruments could be due to two reasons. First, the supply voltage might not match what's on the nameplate, so apply the correct supply voltage. Second, the power supply cable might be incorrectly connected; in that case, check the terminal assignment.
General| Brand | Endress+Hauser |
|---|---|
| Model | Proline Promass I 100 |
| Category | Measuring Instruments |
| Language | English |
Specifies qualifications and authorization needed for personnel handling the device.
Defines the intended application and media for the measuring device.
Provides guidelines for personal protective equipment and safety during work.
Covers safe operation, device modifications, and repair guidelines.
Confirms the device's design in accordance with safety standards and EC directives.
Describes general requirements for installing the device without special measures.
Outlines requirements for connecting cables and necessary tools.
Specifies electrical safety, temperature range, and cable type requirements.
Details terminal assignments for transmitters and safety barriers.
Provides pin assignments for device plugs for Modbus RS485 connections.
Explains concepts for electromagnetic compatibility and proper grounding.
Guides on connecting the transmitter and the safety barrier.
Provides a checklist for verifying the electrical connection.
Details how to access device parameters using operating tools like FieldCare.
Ensures post-installation and post-connection checks are performed before commissioning.
Guides on connecting to the device using FieldCare for setup.
Details configuration steps for system units, medium, and communication interface.
Covers advanced configuration options like tag name, calculated values, and sensor adjustment.
Provides general troubleshooting steps for common device issues.
Describes how diagnostic events are displayed in the FieldCare operating tool.
Explains the meaning of status signals and diagnostic information.
Details how to access remedy information and diagnostic data via interfaces.
Covers setting the diagnostic behavior for Modbus communication.
Guides on viewing pending diagnostic events and the event logbook.
To Next Page
