Endress+Hauser Proline Promass I 100 - Commissioning; Function Check; Establishing a Connection via FieldCare; Configuring the Measuring Device

Proline Promass I 100 Modbus RS485 Commissioning
Endress+Hauser 43
10 Commissioning
10.1 Function check
Before commissioning the device, make sure that the post-installation and post-
connection checks have been performed.
• "Post-mounting check" checklist (  23)
• "Post-connection check" checklist (  33)
10.2 Establishing a connection via FieldCare
• For FieldCare connection (  37)
• For establishing a connection via FieldCare (  37)
• For FieldCare user interface (  38)
10.3 Configuring the measuring device
The Setup menu with its submenus contains all parameters needed for standard
operation.
Structure of the "Setup" menu
Setup

System units
(  43)
Select medium
(  46)
Communication
(  47)
Low flow cut off
(  49)
Partially filled pipe detection
(  50)
10.3.1 Setting the system units
In the System units submenu, you can configure the units of all measured values.
Navigation path
"Setup" menu  Advanced setup  System units
Structure of the submenu
System units

Mass flow unit
Mass unit
Volume flow unit
Volume unit
Corrected volume flow unit
Corrected volume unit
Density unit
Reference density unit