Proline Promass I 100 Modbus RS485 Installation
Endress+Hauser 23
6.3 Post-installation check
Is the device damaged (visual inspection)?
Does the measuring device conform to the measuring point specifications?
For example:
• Process temperature ( 86)
• Process pressure (refer to the chapter on "Material load curves" of the "Technical Information"
document)
• Ambient temperature ( 19)
• Measuring range ( 76)
Has the correct orientation for the sensor been selected ?
• According to sensor type
• According to medium temperature
• According to medium properties (outgassing, with entrained solids)
Does the arrow on the sensor nameplate match the direction of flow of the fluid through the
piping ( 18)?
Are the measuring point identification and labeling correct (visual inspection)?
Is the device adequately protected from precipitation and direct sunlight?
Are the securing screw and securing clamp tightened securely?
To Next Page
Loading...
