Endress+Hauser Proline Promass I 100 - Certificates and Approvals

Technical data Proline Promass I 100 Modbus RS485
90 Endress+Hauser
Process connections
• Flanges according to EN 1092-1 (DIN 2501) / according to ASME B16.5/ according to
JIS:
– Stainless steel 1.4301 (304),
– Wetted parts: Grade 2 titanium
• All other process connections:
Grade 2 titanium
List of all available process connections (  90)
Seals
Welded process connections without internal seals
Safety Barrier Promass 100
Housing: Polyamide
Process connections • Flanges:
– EN 1092-1 (DIN 2501)
– ASME B16.5
– JIS B2220
• Tri-Clamp (OD tubes)
• Clamp (eccentric) :
Tri-Clamp
• Threaded hygienic connection:
– DIN 11851
– SMS 1145
– ISO 2853
– DIN 11864-1 Form A
• Flange:
DIN 11864-2 Form A
For information on the materials of the process connections (  89)
16.11 Operability
Remote operation Service interface (CDI)
Operation of the measuring device with the service interface (CDI) via:
"FieldCare" operating tool with COM DTM "CDI Communication FXA291" via Commubox
FXA291
Languages Can be operated in the following languages:
Via "FieldCare" operating tool:
English, German, French, Spanish, Italian, Chinese, Japanese
16.12 Certificates and approvals
CE mark The measuring system is in conformity with the statutory requirements of the applicable
EC Directives. These are listed in the corresponding EC Declaration of Conformity along
with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.