To Next PageTo Next Page
Need help?Do you have a question about the Endress+Hauser Promag 300 and is the answer not in the manual?
General| Measuring Principle | Electromagnetic |
|---|---|
| Housing Material | Aluminum, Stainless steel |
| Medium Temperature Range | -20 to +150 °C |
| Process Pressure Range | Up to 40 bar |
| Output Signals | 4-20 mA, HART |
| Power Supply | 24 V DC, 100-240 V AC |
| Protection Class | IP66/67 (Type 4X enclosure) |
| Lining | PTFE |
| Electrode Material | Stainless steel, Tantalum, Platinum |
| Certifications | ATEX, IECEx |
Details which application packages are valid for specific device order codes.
Defines personnel authorized to perform device alterations based on approval status.
Specifies personnel authorized to affix new nameplates based on approval status.
Lists the tools required for performing the alteration procedures.
Provides explanations for DANGER, WARNING, CAUTION, and NOTICE symbols.
Defines symbols indicating allowed actions, forbidden actions, tips, and steps.
Step-by-step guide to activate software using the device's display interface.
Instructions for activating software options using a web server connection.
Procedure for activating software options using the FieldCare application.
Details on verifying and recording device tag information after activation.
