Endress+Hauser RIA 261 - Auxiliary Energy

RIA261
Endress+Hauser 3
Output
Output signal The analogue input signal (4 to 20 mA) is not converted. The input signal is digitised, analysed and shown in
the LC display.
Signal on alarm No measured value seen in the LC display, no rear illumination.
Transmission behaviour The display allows transmission of the HART
®
transmission protocol.
Auxiliary energy
Electrical connection
Field mounted display terminal layout
Supply voltage The power supply is done using the 4 to 20 mA current loop power.
Volt drop:
< 2.5 V
Cable entry 2 x M20 cable entries
Alternative:
2 x ½" NPT cable entries
Terminal In- and outputs
1 Measurement signal (+) 4 to 20 mA Signal input
2 Connection terminal for further instrumentation Terminal
3 Measurement signal (-) 4 to 20 mA Signal input
4 Connection terminal for further instrumentation Terminal
G09-RIA261ZZ-04-00-xx-en-001.eps
active
passive