RIA261
Endress+Hauser 5
Mechanical construction
Design, dimensions
Unit dimensions in mm
Dimensions for wall mounting holes (lower picture) in mm
• There is room available behind the hinged electronics for additional electronics e.g. temperature head trans-
mitter. Take note of manufacturers installation instructions!
Internal dimensions: H = 60 mm, W = 140 mm, D = 30 mm
• Housing can be lead sealed
•GORE-TEX
®
membrane used as pressure compensation fitted to the left of the cable entries
Weight Approx. 800 g
Material Housing
Die cast aluminium epoxy coated with glass insert
Wall/stand pipe mounting kit and tensioning tape
1.4301 stainless steel
Terminals • Plug in screw terminals inside the housing in order enable loop current connection:
Plug on screw terminals, terminal size 1.5 mm² solid core, 1.0 mm² stranded with ferrule
• Earth (ground) connection on housing exterior: Terminal range 2.5 mm²
G09-RIA261ZZ-06-00-08-xx-002.eps
To Next Page
Loading...
