Endress+Hauser RIA452 - Device Commissioning

Commissioning RIA452
20 Endress+Hauser
6 Commissioning
6.1 Function check
Make sure that all post-connection checks have been carried out before you commission
your device:
• Checklist Section 4.3 'Post-connection check'
6.2 Switching on the measuring device
Once the operating voltage is applied, the green LED indicates that the instrument is
operational.
• When the unit is delivered, the device parameters are used as per the factory settings.
• When commissioning a device already configured or preset, measuring is immediately
started as per the settings. The limit values only switch once the first measured value has
been determined.
• The limit values are only activated as per their configuration once a valid measured value
is present.
6.3 Device configuration
This section describes all the configurable instrument parameters with the associated value
ranges and factory settings (default values, marked in bold).
6.3.1 Analog input - INPUT/M1
All the parameters that can be selected for the input can be found under the analog input
menu item which is marked as INPUT in the device.
Remove the protective strip from the display as this restricts display legibility
otherwise.
Function
(menu
item)
Parameter setting Description
Signal type 4 - 20 mA
0 - 20 mA
0 - 5 mA (*)
0 - 100 mV (*)
0 - 200 mV (*)
0 - 1 V (*)
0 - 10 V (*)
± 150 mV (*)
± 1 V (*)
± 10 V (*)
± 30 V (*)
Type B (IEC584) (*)
Type J (IEC584) (*)
Type K (IEC584) (*)
Type L (DIN43710) (*)
Type L (GOST) (*)
Type N (IEC584) (*)
Type R (IEC584) (*)
Type S (IEC584) (*)
Type T (IEC584) (*)
Type U (DIN43710) (*)
Type D (ASTME998) (*)
Type C (ASTME998) (*)
Selects the signal type of the connected sensor.
Parameters marked with an asterisk (*) can only be
selected with the universal input option.