RIA452 Commissioning
Endress+Hauser 33
Totalizer 9999999 In this position, the totalizer can be displayed and edited (e.g. assigned
a default value).
The counter starts again at 0 if the maximum value of 9999999 is
exceeded.
Reset total No
Yes
Reset totalizer
Cannot be configured via ReadWin
®
2000.
Calc. flow No
Curve
Formula
For selecting a method of calculating the total flow based on the
channel type or by means of a formula using the analog input signal
(e.g. level signal)
• No = no integration
• Curve = flow calculated with channel type.
If "Curve" is selected, the menu only displays possible channel types
for configuration (e.g. Venturi channels, Parshall channels, weirs
etc.)
• Formula = flow calculated using a formula
If "Formula" is selected, the menu only displays possible
configuration parameters for entering the formula (Alpha, Beta,
Gamma, C).
Here, the flow is calculated using the following formula:
Dim. input mm
inch
Dimension of the channel size
Dec. flow XXXXX
XXXX.X
XXX.XX
XX.XXX
X.XXXX
Decimal point for display
Dim. flow m3/s, l/s, hl/s,
igal/s, usgal/s,
barrels/s, inch3/s,
ft3/s, Usmgal/s,
Ml/s, m3/smin, l/
min, hl/min, igal/
min, usgal/min,
barrels/min,
inch3/min, ft3/
min, Usmgal/min,
Ml/min, m3/h, l/
h, hl/h, igal/h,
usgal/h, barrels/h,
inch3/h, ft3/h,
Usmgal/h, Ml/h
Dimension of linearized value
•l = liter
• hl = hectoliter
•m
3
= cubic meter
• Ml = megaliter
• USgal = US gallon
• USKgal = US kilogallon
• USMgal = US megagallon
• USbl = US barrel
• igal = imperial gallon
• ibl = imperial barrel
•inch = inch
•ft = feet
1 hl = 100 l
1 m
3
= 1,000 l
1 Ml = 1,000,000 l
1 USgal = 3.79 l
1 USKgal = 3,785.41 l
1 USMgal =
3,785,411.78 l
1 USbl = 119.24 l
1 igal = 4.55 l
1 ibl = 163.66 l
1 inch = 25.4 mm
1 ft = 304.8 mm
Dec. point XXXXX
XXXX.X
XXX.XX
XX.XXX
X.XXXX
Decimal point for formula
(only if formula-based flow calculation is selected)
Alpha -99.99999 Flow rate exponent α (see Calc.flow)
Beta -99.99999 Flow rate exponent β (see Calc.flow)
Gamma -99.99999 Weighting factor γ
C -100 Scaling constant C (see Calc.flow)
Function
(menu
item)
Parameter
setting
Description
To Next Page
Loading...
