Endress+Hauser SS500 - Page 10

2-Pack Analyzer System
vi 4900002256 rev. B 4-13-21
Figure A–8. Power and signal wiring diagram, fixed mount, non-validation,
optional analyzer electronics port for 2-Pack analyzer system . . . A-12
Figure A–9. Power and signal wiring diagram, fixed mount, non-validation,
optional air-actuated valve for 2-Pack analyzer system . . . . . . . . A-13
Figure B–1. Measurement cell types . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-5
Figure B–2. Stainless steel mirror marking . . . . . . . . . . . . . . . . . . . . . . . . . . B-5
Figure B–3. Stainless steel mirror - mirror side up . . . . . . . . . . . . . . . . . . . . . B-9
Figure B–4. SCS cabinet interior . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-11
Figure B–5. Removed 28 m measurement cell . . . . . . . . . . . . . . . . . . . . . . . B-11
Figure B–6. Removing the old pressure sensor . . . . . . . . . . . . . . . . . . . . . . B-12
Figure B–7. Removing excess seal tape from flange . . . . . . . . . . . . . . . . . . . B-12
Figure B–8. Removing excess seal tape from inside cell . . . . . . . . . . . . . . . . B-13
Figure B–9. Replacing seal tape . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-13
Figure B–10. Replacing pressure sensor . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-14
Figure B–11. New pressure sensor installed . . . . . . . . . . . . . . . . . . . . . . . . . B-14
Figure B–12. Removed 0.8 m measurement cell with pressure sensor
face up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-16
Figure B–13. Removing the old pressure sensor . . . . . . . . . . . . . . . . . . . . . . B-16
Figure B–14. Removing excess seal tape from flange . . . . . . . . . . . . . . . . . . . B-17
Figure B–15. Replacing seal tape . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-17
Figure B–16. Replacing pressure sensor . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-18
Figure B–17. Newly installed pressure sensor positioning . . . . . . . . . . . . . . . . B-18
Figure B–18. Predicted scrubber lifetime based on average H
2
S load . . . . . . . . B-23
Figure B–19. Scrubber and scrubber efficiency indicator . . . . . . . . . . . . . . . . . B-24
Figure B–20. H
2
S scrubber efficiency indicator before and after
breakthrough . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-25