Safety Instructions
3
1Safety Instructions
1.1 Designated use
Tankvision is a dedicated tank inventory management system.
Components:
• Tankvision Tank Scanner NXA820
scans parameters from tank gauges and performs tank calculations
• Tankvision Data Concentrator NXA821
summarizes data from various Tank Scanners NXA820
• Tankvision Host Link NXA822
provides data to host systems (such as PLC or DCS) via Modbus
The above mentioned components are operated via a standard web browser. It does not require any
proprietary software. Tankvision is based on a distributed architecture on a Local Area Network
(LAN). Due to its modular structure it can be adjusted to any application. It is ideally suited for small
tank farms with only a couple of tanks, but also for large refineries with hundreds of tanks.
1.2 Installation, commissioning, operation
The Tankvision system is fail-safe and constructed to the state-of-the-art. It meets the appropriate
standards and EC directives. However, if you use it improperly or other than for its designated use,
it may pose application-specific hazards, e.g. product overflow due to incorrect installation or
configuration. Installation, electrical connection, start-up, operation and maintenance of the devices
must therefore be carried out exclusively by trained specialists authorised by the system operator.
Technical personnel must have read and understood these operating instructions and must adhere
to them. You may only undertake modifications or repair work to the device when it is expressly
permitted by the operating instructions.
To Next Page
Loading...
