Viomax CAS51D Basic safety instructions
Endress+Hauser 5
2.4 Operational safety
1. Before commissioning the complete measuring point, verify that all connections are
correct. Ensure that electrical cables and hose connections are undamaged.
2. Do not operate damaged products, and protect them against unintentional operation.
Label the damaged product as defective.
3. If faults cannot be rectified,
products must be taken out of service and protected against unintentional operation.
2.5 Product safety
The product is designed to meet state-of-the-art safety requirements, has been tested, and
left the factory in a condition in which it is safe to operate. The relevant regulations and
European standards have been observed.
To Next Page
Loading...
