10
5. Route the Ethernet cable through the small end of the gland base. Align the RJ-45
connector appropriately, then snap the connector into place. Ensure that the connector
is fully connected before continuing.
6. Unscrew the protective cap on the boom of the JuiceRouter.
7. Connect the Ethernet cable to the po on the base of the JuiceRouter. Fully tighten the
gland.
NOTE
The POE injector and AC adapter are not outdoor rated and must be installed inside
or in a sealed outdoor enclosure. Failure to do so will result in corrosion and damage
to the JuiceRouter.
8. Connect the other end of the Ethernet cable to the PoE injector.
9. Connect the PoE injector to power.
To Next Page
Loading...