14 www.ener-c.com www.ener-c.com 15
H. CTM Exchanger®
Cat. no.
CMS-01
MMM-01
MML-01
Description
Multi-purpose
small
Multi-purpose
medium
Multi-purpose
large
Maximum
size
55 cm (22“)
70 cm (28“)
84 cm (33“)
Application
For limbs and ankles
1
2
3
Appendix A – Explanation of symbols
Manufacturer
Type BF Applied Part.
Classication required for medical
devices that come in direct
contact with the patient
Consult Instructions for use
Refer to instruction manual/
booklet
Keep away from sunlight
Do not use if package is damaged
Serial Number
Indoor use only
Storage temperature limits
Storage relative humidity limits
The device complies with
European Directive MDD 93/42
EEC
Catalogue Number
Batch code
Caution / Warning
Keep dry
Fragile, handle with care
Protection against harmful ingress
of water or particulate matter
(Achieved with transport water
proof bag)
Alternating current
Waste Electrical and Electronic
Equipment (WEEE) Symbol
Product owners should refer
to their specic state and
government regulatory guide-
lines for proper disposal.
NOTE: Choose the correct size of the exchanger to completely cover the area to treat with
the pad where water circulates.
Cleaning the CTM Exchanger®
The CTM Exchanger® can be cleaned by wiping the plastic surface with a mild washing-up liquid in
water. Then wipe o the residual washing-up liquid with clean water. Allow to dry before using.
The CTM Exchanger® may be cleaned in this way as often as you like. It is recommended to clean
the CTM Exchanger® between uses.
NOTE: Do not under any circumstances use alcohol, aggressive cleaning agents or disinfectants
to clean the CTM Exchanger®.
NOTE: The exchangers shall be used only for one patient. In case more than one patient is treated
a new CTM Exchanger® must be used.
Ener-C | CTM Controller® 1600 | Operating manual | H. CTM Exchanger® | Rev. 1.1 | 2017-12-12 Ener-C | CTM Controller® 1600 | Operating manual | Appendix A – Explanation of symbols | Rev. 1.1 | 2017-12-12
5 °C
40 °C
IP 21
10%
90%
To Next Page
Loading...