Enerdrive ePRO Plus Battery Monitor Owners Manual (Rev. 1.03)Page 34
The monitor does not automatically
synchronize
•
The battery is not reaching its fully charged
state. Please check if the charge algorithm
matches the requirements of your battery.
Do not interrupt the charge process before
it is nished.
•
Consider setting Advanced Function A01 to
‘LEGACY’ and tweak Functions A02 – A05 to
better match it to your system.
The monitor synchronizes too early •
In some systems (like solar) the charge
current can uctuate heavily, causing the
battery monitor to consider the battery
fully charged too early. In this case, Function
A01 can be set to ‘LEGACY’ and Function
A02 approx. 0.2V-0.3V below the absorption
voltage.
To Next Page
Loading...
