The Elliptical is supplied with an external power supply. When power is connected to the Elliptical,
the console will automatically power up. If there is no input to the console for 20 minutes the
console will go to stand-by mode. In stand-by mode the console display will turn off. To turn the
console on press any key.
When initially powered on the console will perform an internal self-test. During this time all the lights
will turn on. When the lights go off the dot matrix display will show a software version. The
odometer reading displays how many hours the elliptical has been used and how many virtual
kilometers the elliptical has gone. The display will look like this: ODO 12.34 （KM）12：34
（HRS：MINS）
The odometer will remain displayed for only a few seconds then the console will go to the start up
display. You may now begin to use the console.
To Next Page
Loading...
Need help?
General
