2
The Switch Module based on Z-Wave
TM
Slave library of V7.18.03. This Switch integrated Z-Wave
communication module to connect with Z-Wave gateway.
The Switch Module can be included and operated in any Z-Wave network with other Z-Wave
certified devices from other manufacturers and/or other applications. All non-battery operated
nodes within the network will act as repeaters regardless of vendor to increase reliability of the
network.
The Switch Module is a security Z-Wave device (S2), so a security enabled controller is needed for
take full advantage of all functionally for the Switch Module.
Features:
⚫
Manual or Z-Wave on/off control of 2 electrical loads.
⚫
Add Z-Wave to two wall switches with a single device.
⚫
Installs behind your existing wall switch.
⚫
Remembers and restores on/off status after power failure.
⚫
Built-in Z-Wave signal repeater.
⚫
SmartStart and S2 Security for a safer network.
1 Technical Specifications
To Next Page
Loading...
