ENFORCER Auto Dialer
4 SECO-LARM U.S.A., Inc.
Low Battery LED
LCD Display
Numeric Keypad
Mounting Points
Terminal Block
Reset Button
Battery Receptacle (Battery not included)
Siren Speaker
LINE Jack
DC Power Jack (for 3.5mm phone plug
adapter, not included)
Home Mode Button
Back (Covers Removed)
PASSWORD
PASSWORDPASSWORD
PASSWORD
MEMORY
MEMORYMEMORY
MEMORY
LEARN
LEARNLEARN
LEARN
℡
℡℡
℡
CYCLE
CYCLECYCLE
CYCLE
ENTRY
ENTRYENTRY
ENTRY
ARM
ARMARM
ARM
TRIGGER HOME
TRIGGER HOMETRIGGER HOME
TRIGGER HOME
Alarm Triggered
Note: For explanation of these symbols, please see Programming the Auto Dialer on pages 6~9.
ENFORCER Auto Dialer
SECO-LARM U.S.A., Inc. 13
SL-1301-BAQ
Magnetic Contacts, etc.
E-921CPQ
SS-040Q
SS-072Q
E-931-S35RRQ
When the charge level of the 9VDC backup battery (not included) is low, the “LOW BATT.” LED
will flash once every 1.5 seconds. Replace the battery in order to continue providing functionality
during a temporary disruption in power.
to avoid potential damage due to battery leakage
o not leave a low battery in
the unit. Also, be sure to remove the battery if the unit is unused for a period of time.
To view the last 5 sensor trigger events, while in standby mode press the [#/DOWN] button.
To view stored emergency telephone numbers, while in standby mode press the [*/UP] button.
After 10 seconds of inactivity, the dialer will automatically exit the
to standby.
LARM products, please visit us online at www.seco
1. Make sure that the full telephone numbers have been stored as they would normally be dialed
from a local phone.
2. The auto dialer is only suitable for single phone lines. It is not compatible with fax machines.
3. Set the number of Call-in rings to be less than the voicemail or message answer point.
®
To Next Page
Loading...
Need help?
General
