4 Installation
4. Installation
It is important to check the necessary additional documentation before installation. At time
of delivery, your product and supplementary documentation are as far as possible adapted
to your base machine.
WARNING
If you have any doubts concerning the safety aspects
of your knowledge, the equipment or work, contact
a dealer or engcon Nordic AB. Incorrect installation
affect safety.
WARNING
Switch off power when working on the electrical
system and remove any live objects before starting
work Risk of personal injury.
IMPORTANT
Assembly and installation may only be carried out at a
workshop authorised by the manufacturer. Changes to the
assembly may not be carried out without the manufacturer’s
consent.
4.1. Responsibility
This installation kit is designed to be installed on machines specified by the kit and
installation instructions. The kit is designed to emulate a signal from a factory-installed
control device, control a valve connected in parallel or alternatively affect a valve already
installed on the machine.
In the event that the kit is a generic kit, the installer of the kit is responsible for ensuring
that the machine has maintained safety and that the machine kit when connected does not
change or otherwise affect the machine's procedure in the event of a fault.
The procedure for faults must be the same with the installation kit installed as for faults
on the original function or control unit. The procedure in the event of a fault is thus the
same, with or without the installation kit, and the installation kit thus has no additional
requirements for safety or hydraulic safety valve.
10
To Next Page
Loading...
Need help?
General