1 Introduction
1. Introduction
1.1. General
These installation instructions contain important information about how your product
is assembled and installed. Before you begin to assemble and use the product, it is
important that you read and understand the contents of the installation instructions,
especially the sections describing safety.
In addition to these installation instructions, you must read and understand the applicable
safety information for the relevant base machine as well as any other equipment.
Information, images, illustrations and specifications are based on the product information
available at the time of printing the installation instructions. Images and illustrations in the
installation instructions are typical examples and are not intended to be exact depictions of
different parts of the product. We reserve the right to make changes without prior notice.
Always make sure you have the latest version of the installation instructions. You can find
the latest version by logging in to www.engcon.com.
1.2. Scrapping and recycling
engcon makes constant efforts to reduce its environmental impact. engcon's products
comprise at least 99 per cent recyclable material. All assembly and service work must
take place in compliance with legislation and ordinances governing the environment,
health and occupational safety. This refers to all work with residual materials including
handling, storage and processing. To prevent contamination of soil and water, spillages
must be avoided. Should a spillage occur, it must be dealt with.
Hazardous waste may only be disposed of by those authorised to do so. All waste
produced must be disposed of in compliance with applicable legislation and ordinances:
- Metal and plastics to be recycled.
- Hydraulic hoses are normally used for energy recovery (sort as hazardous waste).
- Oils and greases are normally used for energy recovery (sort as hazardous waste).
- Electronic components to be recycled for materials (sort as hazardous waste).
- Packaging to be sorted at source and recycled for materials.
- Paper to be sorted at source and recycled for materials.
If in doubt, contact the environmental manager at engcon.
1.3. Technical support and spare parts
Contact information for support and spare parts can be found at www.engcon.com.
5
To Next Page
Loading...
Need help?
General