Need help?Do you have a question about the EnGenius EAP1750H and is the answer not in the manual?
General| Modulation | 64-QAM, BPSK, CCK, DBPSK, DQPSK, OFDM, QPSK |
|---|---|
| Frequency band | 2.4, 5 GHz |
| Operating modes | Access Point (AP), WDS Access Point (AP), WDS Bridge |
| Channel bandwidth | 40 MHz |
| Channels quantity | 11 channels |
| Transmitting power | 16 dBmW |
| Networking standards | IEEE 802.11a, IEEE 802.11ac, IEEE 802.11b, IEEE 802.11e, IEEE 802.11g, IEEE 802.11n, IEEE 802.3at |
| Virtual LAN features | Tagged VLAN |
| Spread spectrum method | DSSS |
| Ethernet LAN data rates | 10, 100, 1000 Mbit/s |
| Maximum data transfer rate | 1300 Mbit/s |
| Quality of Service (QoS) support | Yes |
| Flash memory | 16 MB |
| Internal memory | 128 MB |
| Internal | No |
| Placement | Ceiling, Wall |
| Certification | FCC, IC, CE |
| Product color | White |
| LED indicators | LAN, Power, WPS |
| Cable lock slot type | Kensington |
| WAN connection | Ethernet (RJ-45) |
| USB 2.0 ports quantity | 0 |
| Ethernet LAN (RJ-45) ports | 1 |
| VPN support | IPsec, L2TP, PPTP |
| Security algorithms | 802.1x RADIUS, MD5, PEAP, SSID, TKIP, WPA, WPA-AES, WPA-EAP, WPA-PSK, WPA-TKIP, WPA2 |
| Antenna features | Integrated antenna |
| Antennas quantity | 6 |
| Antenna gain level (max) | 5 dBi |
| Input current | 2 A |
| AC input voltage | 90 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Storage temperature (T-T) | -20 - 60 °C |
| Operating temperature (T-T) | 0 - 40 °C |
| Operating relative humidity (H-H) | 0 - 90 % |
| Cables included | LAN (RJ-45) |
Weight and Dimensions| Width | 161.54 mm |
|---|---|
| Height | 41.5 mm |
| Weight | 290 g |
Details hardware and software specifications, including interfaces, modes, and environmental conditions.
Guides configuring computer TCP/IPv4 settings for initial access point setup.
Explains default IP address, username, and password for accessing the device configuration.
Describes operating as a central connection for wireless clients, supporting multiple SSIDs.
Configuration of basic IP settings (IPv4/IPv6) for the access point.
Configuration of device name, country, and band steering options for wireless operation.
Setup of wireless network parameters including operation mode, channel, and bandwidth.
Configuration of security modes like WEP, WPA/WPA2 for wireless network protection.
Setup of isolated guest networks for visitors on 2.4GHz and 5GHz bands.
Allows changing the administrator username and password for system access.
Guides on how to upgrade the access point's firmware to the latest version.
Enables saving current configurations and restoring them from a file or to factory defaults.
Options to reboot the device or reset it to factory or user default settings.
To Next Page
