Need help?Do you have a question about the EnGenius ENS200 and is the answer not in the manual?
General| Frequency Band | 2.4 GHz |
|---|---|
| Maximum Data Rate | 300 Mbps |
| Antenna Type | Internal |
| Antenna Gain | 5 dBi |
| Ethernet Ports | 1 x 10/100 Mbps |
| Power over Ethernet (PoE) | 802.3af |
| Operating Temperature | -20°C to 70°C |
| Mounting Options | Wall |
| Operating Modes | Access Point, WDS |
| Security | WPA/WPA2, WEP |
Provides step-by-step instructions for mounting and connecting the ENS200 device.
Explains the steps required to log in to the ENS200's web configuration interface.
Configures system properties and operational modes of the ENS200.
Configures the LAN settings for the ENS200, including static or dynamic IP addressing.
Configures the ENS200 as a router, including WAN settings.
Configures the Local Area Network (LAN) settings, including IP address and DHCP server.
Configures wireless network parameters like SSID, channel, and bandwidth.
Configures the ENS200 to bridge two LAN segments wirelessly.
Creates wireless networks by linking multiple access points using WDS links.
Configures the ENS200 to access the internet wirelessly via a WISP or wired modem.
Configures wireless network security settings, including WEP, WPA, and WPA2.
Configures advanced network features like traffic shaping and bandwidth limits.
Manages device settings including administrator account, remote access, and firmware.
Details the process for updating the ENS200 firmware.
To Next Page
