Need help?Do you have a question about the EnGenius EAP300 and is the answer not in the manual?
General| 5 GHz | No |
|---|---|
| Modulation | 16-QAM, 64-QAM, BPSK, CCK, DBPSK, DQPSK, OFDM, QPSK |
| Frequency band | 2.412 - 2.472 GHz |
| Operating modes | Access Point (AP), Repeater, WDS |
| Channel bandwidth | 40 MHz |
| Channels quantity | 11 channels |
| Transmitting power | 15 dBmW |
| Networking standards | IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.1D, IEEE 802.3af |
| Virtual LAN features | Tagged VLAN |
| Spread spectrum method | DSSS |
| Ethernet LAN data rates | 10, 100 Mbit/s |
| Maximum data transfer rate | 300 Mbit/s |
| Quality of Service (QoS) support | Yes |
| Antenna features | Integrated antenna |
| Antennas quantity | 2 |
| Antenna gain level (max) | 5 dBi |
| Placement | Ceiling, Wall |
| Certification | FCC, CE, IC |
| Product color | White |
| WAN connection | Ethernet (RJ-45) |
| USB 2.0 ports quantity | 0 |
| Ethernet LAN (RJ-45) ports | 1 |
| Security algorithms | 128-bit WEP, 64-bit WEP, 802.1x RADIUS, SSID, WEP, WPA, WPA-PSK, WPA-TKIP, WPA2, WPA2-PSK |
| Number of SSID supported | 8 |
| Storage temperature (T-T) | -20 - 60 °C |
| Operating temperature (T-T) | 0 - 50 °C |
| Operating relative humidity (H-H) | 0 - 90 % |
| Input current | 1 A |
| AC input voltage | 12 V |
| Power supply type | 48V DC, 0.375A |
| Power requirements | 90 - 240V AC, 50/60Hz |
| Flash memory | 4 MB |
| Internal memory | 32 MB |
Weight and Dimensions| Width | 125.63 mm |
|---|---|
| Height | 63.58 mm |
| Weight | 224 g |
Specifies the default IP address, username, password, SSID, and security for the access point.
Guides users to access the device's web-based configuration interface via a browser.
Modifies the device's IP address, subnet mask, and gateway settings.
Configures general wireless settings like SSID, channel, and basic parameters.
Configures security modes (WEP, WPA-PSK, WPA2-PSK) for wireless networks.
Upgrades the EAP300's firmware to the latest version.
To Next Page
