EnGenius EAP300 - Wireless Mac Filter

49
7.4 Wireless MAC Filter
Wireless MAC Filtering is used to allow or deny network access to wireless clients (computers, tablet PCs, NAS,
smartphones, etc.) according to their MAC addresses. You can manually add a MAC address to restrict the permission to
access EAP300. The default setting is Disabled .
Note: Only in Access Point, WDS AP and Repeater mode.
Wireless Filter (Access Point / WDS AP / Repeater mode)
ACL Mode Determines whether network access is granted or denied to clients whose MAC addresses
appear in the MAC Address table on this page. Choices are Disabled, Deny MAC in the List or
Allow MAC in the List.
MAC Address Enter the MAC address of the wireless client.
Add Click Add to add the MAC address to the MAC Address table.
Delete Click Delete to delete the MAC address from the MAC Address table.
Apply Click Accept to apply the changes.