Need help?Do you have a question about the EnGenius EAP150 and is the answer not in the manual?
General| Modulation | 16-QAM, 64-QAM, BPSK, CCK, DBPSK, DQPSK, OFDM, QPSK |
|---|---|
| Frequency band | 2.412 - 2.472 GHz |
| Networking standards | IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.1D, IEEE 802.3af |
| Ethernet LAN data rates | 10, 100 Mbit/s |
| Maximum data transfer rate | 150 Mbit/s |
| Quality of Service (QoS) support | Yes |
| Antenna gain level (max) | 5 dBi |
| Internal | No |
| Certification | FCC, CE, IC |
| WAN connection | Ethernet (RJ-45) |
| Ethernet LAN (RJ-45) ports | 1 |
| Security algorithms | 128-bit WEP, 64-bit WEP, 802.1x RADIUS, SSID, TKIP, WEP, WPA, WPA-AES, WPA-PSK, WPA-TKIP, WPA2, WPA2-PSK |
| Storage temperature (T-T) | -20 - 60 °C |
| Operating temperature (T-T) | 0 - 50 °C |
| Operating relative humidity (H-H) | 0 - 90 % |
| Input current | 1 A |
| AC input voltage | 12 V |
| Power supply type | 48V DC, 0.375A |
| Power requirements | 90 - 240V AC, 50/60Hz |
| Flash memory | 4 MB |
| Internal memory | 32 MB |
Weight and Dimensions| Weight | 280 g |
|---|
Provides guidelines for optimal wireless signal strength, placement, and potential interference sources.
Explains the physical connection process for the access point, including cable and power connections.
Lists the default IP address, username, password, and wireless SSID for the access point.
Provides instructions for accessing and logging into the device's web-based configuration interface.
Allows selection of operating modes like Access Point, WDS AP, or WDS Bridge.
Configures wireless security using WEP, WPA-PSK, WPA2-PSK, or WPA-RADIUS authentication.
Manages MAC address filtering to control which wireless clients can access the network.
Allows changing the default password and configuring remote management settings.
Provides instructions for upgrading the device's firmware using a local file.
To Next Page
