[pg.73]
Go to the Network tab
VPN Server IP Setting
Server IP: enter an IP address which is different from your router’s LAN IP address. (example: the default LAN IP of ESR300H is 192.168.0.1. You
could create a Server IP address as 10.2.2.1)
Remote IP Range: enter an IP range under the same subnet of the above Server IP. (example: if your Server IP address is 10.2.2.1, you could
create the remote IP Range as 10.2.2.10 – 20. The remote IP range should not include Server IP address to avoid duplicate IP addresses within the
same network.)
Click Apply to save the L2TP VPN profile setting.
To connect to the VPN tunnel, you can use your native Windows VPN client.
To Next Page
Loading...
