44
Authentication Mode: It shows the active authentication mode for the wireless connection.
Passphrase Key: It shows the passphrase key that is randomly generated by the wireless
router during the WPS process. You may need this information when
using a device which doesn’t support WPS.
Interface: If device is set to repeater mode, you can choose “Client” interface to connect
with other AP by using WPS, otherwise you may choose “AP” interface to do
WPS with other clients.
WPS via Push Button: Press the button to start the WPS process. The router will wait for
the WPS request from the wireless devices within 2 minutes.
WPS via PIN: You can fill-in the PIN code of the wireless device and press the button to
start the WPS process. The router will wait for the WPS request from the
wireless device within 2 minutes.
To Next Page
