Temperature Gauge (Where Fitted)
The temperature gauge enables a close check to be kept on the coolant
temperatures.
Malfunction Indicator Light (Where Fitted)
Used on all industrial engines. This light will illuminate whenever there is an engine
malfunction such as low oil pressure, high engine temperature, fuel injection system
fault. The engine can be programmed to shut down in the event of a malfunction.
Charge Indicator Light (Where Fitted)
If an alternator is fitted to your engine, a charge indicator light may also be fitted.
The light will glow when the isolating switch is in the RUN position with the engine
stationary and will therefore serve as a reminder either to turn the isolating switch to
the OFF position or to start the engine. Once the engine has started, the charge
indicator light should cease glowing.
Ignition or Isolation Switch
-- Refer to “Ignition or Isolation Switch” on page 13.
Fuel Select Switch (Where Fitted)
This switch is incorporated for use with dual fuels. Switch must point to selection of
fuel being used.
WARNING: ALL INTERNAL COMBUSTION ENGINES GIVE OFF VARIOUS
FUMES AND GASES WHILE RUNNING. DO NOT START OR RUN THE ENGINE
IN A CLOSED OR POORLY VENTILATED BUILDING WHERE THE EXHAUST
GASES CAN ACCUMULATE. AVOID BREATHING THESE GASES AS THEY
MAY CONTAIN POISONOUS CARBON MONOXIDE WHICH CAN ENDANGER
YOUR HEALTH OR LIFE IF INHALED STEADILY FOR EVEN A FEW MINUTES.
On initial start-up follow the daily regular maintenance schedule illustration -- Refer
to “RECOMMENDED MAINTENANCE SCHEDULES” on page 22.
To Next Page
Loading...
Need help?
General
