15
Malfunction Indicator Light (Where Fitted)
Used on all industrial engines. This light will illuminate whenever there is an engine malfunction
such as low oil pressure, high engine temperature, fuel injection system fault. The engine can be
programmed to shut down in the event of a malfunction.
Charge Indicator Light (Where Fitted)
If an alternator is fitted to your engine, a charge indicator light will also be fitted. The light will glow
when the isolating switch is in the RUN position with the engine stationary and will therefore serve
as a reminder either to turn the isolating switch to the OFF position or to start the engine. Once the
engine has started, the charge indicator light should cease glowing.
Safety Switch Override Button (Where Fitted)
This must be depressed when starting the engine, as the safety switch operates when the oil
pressure falls due to the engine stopping -- Refer to “Safety Switch (where fitted)” on page 14.
Ignition or Isolation Switch
-- Refer to “Ignition or Isolation Switch” on page 13.
Fuel Select Switch (Where Fitted)
This switch is incorporated for use with dual fuels. Switch must point to selection of fuel being
used.
To Next Page
Loading...
Need help?
General
