24
WARNING: PROTECTIVE GOGGLES MUST BE WORN
TO PROTECT THE
EYES WHEN USING COMPRESSED AIR.
4. Check the gaps of the new spark plugs with a feeler
gauge, and, where necessary, bend the outer
ground extension to achieve the specified gap.
5. Use a proper spark plug spanner to avoid damaging
the insulators, screw the new spark plugs into the
cylinder head and tighten them to the specified
torque value listed under specification of this manual.
NOTE: Do not over tighten spark plugs as the gap may
change considerably due to the distortion of the plug
outer shell.
6. Coat the inside of each spark plug boot with silicone
dielectric compound D7AZ-1 9A33 1-A (USA) or equivalent, using a small nscrewdriver blade.
7. Install the plug coils and tighten hold down bolt to 5-7 Nm (44-62 in-lb).
NOTE: Coils are interchangeable.
8. Reconnect ignition coil wire connectors.
To Next Page
Loading...
Need help?
General
