Installation Instruction
7. Install Seat Tube.
7.1 First connect the seat and the seat tube.
7.2 Insert seat post into post receiver,
set right its position and adjust height
to fit your ridding habit.Tighten seat
by clamp.
8. Adjust angle of brake lever, meter, gear shifter, throttle and louder controller on
handlebar, then tightens them with tools.
9. Install Battery
9.1 Open the box of battery.
9.2 Tube the battery to correct angle and
insert the battery into the holder gently,
press it down and lock automatically.
10. Change Throttle.（Make sure the throttle complies with local laws）
10.1 Take right side grip.
10.2 Install throttle, lock the throttle
by tools.
10.3 Open controller box and
take out controller.
To Next Page
Loading...
