ENKHO 149727.01 - Preliminary Phases for Use

28
PRELIMINARY PHASES FOR USE
Starting the appliance
Check that the domestic mains voltage is the same as the voltage indicated on the label of the
EFWJDF5IFOQMBDFUIFNBDIJOFPOBGMBUTVSGBDF8BTIUIFUBOLXIFOVTFEGPSUIFGJSTUUJNF
and fill it with cool tap water (MAX 1 litre), and then carefully push it into its seat (Fig. 3). The
suction tube must be inside the tank.
First start-up
After filling the tank with cool tap water, plug it into the electrical outlet, which must be
equipped with grounding unit. Switch on the machine by pressing the button (L) (Fig. 1). The
light (R) will turn on to indicate that the machine is on.
If you are starting the machine for the first time or after a period of time during which it has
not been used, it is recommended that at least one cup of water be allowed to pass through the
boiler’s hydraulic circuit.
Place a container with a capacity of at least half a litre under the coffee spout and Maxi Cappuc-
cino device (Fig. 4). Put switch (Q) on the coffee position (
8BJUUIBUXBUFSDPNFTPVUGSPN
the coupling seat of the filter holder. Open the steam dispensing knob (M) and make water
come out of the Maxi Cappuccino device.
4UPQEJTQFOTJOHTFUUJOHUIFTXJUDI2JOUIFVQQFSQPTJUJPO$MPTFUIFTUFBNLOPC8BJUGPSUIF
light (N) to turn on. At this point the coffee maker is ready to brew coffee.
Fig. 3 Fig. 4