30
How to make coffee with a pod
To make coffee with pods it is necessary to install the 1 cup/pod filter (D), supplied with the
machine (Fig. 9), as follows:
1 Place the pod in the filter ring (Fig. 10).
2 Push the pod with your fingers inward. The pod must be well centred and placed inside the
filter.
3 Now it is possible to put the filter holder in its seat. Tighten the filter holder making sure it
is securely fitted to the flange (Fig. 6).
4 The pod could remain stuck in the upper part of the machine after making the coffee and
when removing filter holder. To remove it, tilt the filter holder (Fig. 11) so the pod can fall
onto it.
In order to always get an excellent cup of coffee, buy the pod that bears the E.S.E. compatibility
mark.
If the pod is not inserted well, or if the filter holder is not tightened firmly, a few drops of water
could leak from the filter holder.
Auto-off function
If the machine is turned on but not in use, the auto-off function operates after about 30 min-
utes. This function puts the machine off. The ON indicator light (R) is off. To restart the machine
press again the power button (L).
Filling the water tank during use
No special operation is necessary when the water in the tank runs out as the machine is equipped
with a special self-priming device. Just unplug the machine, pull out the tank and fill it with
fresh cool water again.
Fig. 9
Fig. 8
Fig. 10 Fig. 11
To Next Page
Loading...
