Ensemble Commissioning: Installer Toolkit Communications
© 2020 Enphase Energy Inc. All rights reserved. July 24, 2020
___________Installer Initials: All steps complete on this page
Decommissioning an Encharge/Enpower While Replacing it On Site
When replacing an Encharge on site the old Encharge or Enpower must be deleted using Installer
Toolkit.
1. Connect to the Envoy using AP mode.
2. Go to Step 2: Devices and Array and select and delete the devices as shown in images
below.
3. Add and provision the new devices as documented steps C and G in the Error!
Reference source not found. section.
To Previous Page
Loading...
