22
5.4 Default settings at the factory
On the LCD display you will find several of the UPS parameters to select. Default
settings are as follows:
Settings Selection Factory default
Output Voltage Setting
100/110/115/120/127
Vac
120V (FOR LV series)
208/220/230/240 Vac 230V (FOR HV series)
Input/Bypass Voltage
±10%
+10/-15%
+15/-20%
+10/-15%
Input/Frequency
±2%
±5%
±7%
±5%
HE Mode Setting On/Off Off
Free Run Mode On/Off On
Bypass Enable/Disable at free run mode Disable/Enable Disable
Alarm silence On/Off Off
Site wiring alarm Enable/Disable Disable
External Battery pack setting 0, 1, 2 0
You may change default settings, but we recommend that this is done after installation and before
starting up loads. Read UPS configurations in chapter 7.2 for more information.
To Next Page
Loading...