Enraf Nonius Radarmed 950+ - HF-Cable and Switching On

ENGLISH
EN109-1435752-42 Page 15 of 29
To plug on the connector
Push on connector
Check to ensure that connector is
secure
To unplug the connector
Pull back ring
Pull out connector
8.9 Switching on and self test
• Switch on the unit using the on/off switch [8].
• Immediately after switching on, the unit carries out a self test
Check that:
• all LED’s light up briefly;
• at the end of the test a beep can be heard.
Contact your supplier if this is not the case.