Entel HT782U - Page 2

Quick Start User Guide V2.9
HT Series
INTRODUCTION
The HT series is a professional range of commercial grade portables
designed and manufactured to meet IP68 specication for total protection
against water and dust intrusion.
To meet your exact requirements, the radio may have been customised by
your Entel authorised dealer. These features will be explained in a separate
guide issued by the dealer.
OPTIONAL ACCESSORIES
Attaching and removing accessories
To attach an accessory, remove the accessory cover by unscrewing the locking
screw anti-clockwise (leave cover attached or store
in a safe place).
Plug the accessory into the socket, then carefully
tighten the locking screw clockwise until nger tight
(do not over tighten or use any implement).
To remove an accessory, unscrew the locking
screw of the accessory by hand in an anti-clockwise
direction.
Ensure you re-t the accessory socket cover (the
radio is not submersible without the socket covered).
BATTERY INFORMATION
Battery charging
1. Connect the AC adapter to the charger pod and plug in.
2. Turn the radio off.
3. Insert the battery pack into the charger pod, either with or without the radio
attached. The charger LED status light changes to red and charging begins.
4. When charging is complete the charger LED status changes from red to
green. A fully discharged battery pack will take approximately 3-6 hours to
recharge.
A ashing red LED on the charger indicates there is a problem with the
battery. Remove the battery from the charger and consult your Entel Dealer.
CAUTION
BATTERY PACK PRECAUTIONS
• Do not recharge the battery pack if it is already fully charged. Doing so may
reduce the life of the battery pack.
• After charging is complete, remove the battery from the charger. If the
power to the charger is turned off and on again, charging will restart and the
battery will become overcharged.
• Please ensure that the radio is turned off before placing it in the charger
and never switch a radio on whilst in the charger.
• Only use Entel branded battery packs and chargers.
• Do not short the battery terminals or dispose of the battery in a re.
• Do not charge the radio and/or battery pack if they are wet.
DANGER
DO NOT DISASSEMBLE OR MODIFY THE BATTERY IN ANY WAY!
Your Entel battery pack incorporates a safety circuit to avoid danger, if the
safety circuit is damaged or bypassed, or the battery cells are damaged
directly, they may generate extreme heat, smoke, rupture and emit ames.
HT700
|
HT446
PACKING LIST
HT Series radio
Li-ion battery pack
Drop in charger
Spring loaded belt clip
High efciency antenna
Quick start user guide