Enterasys RoamAbout RBT-4102 User Manual (English)

Other manuals for Enterasys RoamAbout RBT-4102

Questions and Answers:

A
Amy ReyesJul 31, 2025
What to do if Ethernet/Link LED is off on Enterasys RoamAbout RBT-4102 Wireless Access Point?
- T
  Teresa WhiteAug 1, 2025
  If the Ethernet/Link LED is off on your Enterasys Wireless Access Point, first, ensure that both the access point and the connected device are powered on. Next, check that the cable is properly plugged into both the access point and the corresponding device. Also, verify that you are using the correct type of cable and that its length does not exceed the specified limits. Finally, inspect the cable connections for any defects; replace the cable if necessary.
D
David CervantesAug 6, 2025
How to fix a Power LED that is off on an Enterasys RoamAbout RBT-4102 Wireless Access Point?
- D
  Dustin SmithAug 7, 2025
  If the Power LED is off on your Enterasys Wireless Access Point, the AC power adapter might be disconnected. Check the connections between the access point, the power adapter, and the wall outlet. Alternatively, PoE power to the access point may be disabled at the connected switch port. Verify the switch configuration to ensure that PoE power is enabled for the switch and the specific port, and confirm that the switch hasn't exceeded its power budget, causing it to turn off the port power.
S
Sherry MooreAug 12, 2025
Why is the Power LED Amber on my Enterasys Wireless Access Point?
- A
  Anna McdanielAug 12, 2025
  If the Power LED on your Enterasys Wireless Access Point is amber, the access point has detected a system error. Try rebooting the access point to clear the condition. If the problem persists, contact your local dealer for further assistance.
R
rodriguezyvonneAug 18, 2025
How to troubleshoot Power LED when it's off on Enterasys Wireless Access Point?
- C
  Carrie OlsonAug 18, 2025
  If the Power LED on your Enterasys Wireless Access Point is off, check the connections between the access point, the power adapter, and the wall outlet. Also, verify the switch configuration to ensure PoE power is enabled for the switch and the specific port. Ensure that the switch hasn't exceeded its power budget, which could cause it to turn off the port power.
K
Kayla PalmerAug 25, 2025
What to do if Power LED is amber on Enterasys Wireless Access Point?
- P
  phillipsjamesAug 25, 2025
  If the Power LED on your Enterasys Wireless Access Point is amber, try rebooting the access point. If the condition persists after rebooting, it is recommended to contact your local dealer for assistance.

Enterasys RoamAbout RBT-4102 Specifications

General

Model	RBT-4102
Type	Wireless Access Point
Brand	Enterasys
Frequency Bands	2.4 GHz
Maximum Data Rate	11 Mbps
Wireless Standards	IEEE 802.11b
Wireless LAN Standard	IEEE 802.11b
Data Transfer Rate	11 Mbps
Interface	Ethernet 10Base-T/100Base-TX
Power over Ethernet	Yes
Data Link Protocol	Ethernet
Ports	1 x 10/100Base-TX (RJ-45)
Operating Temperature	0 to 40 °C
Humidity	10% to 90% (non-condensing)
Power Supply	12V DC

Related product manuals

Enterasys RoamAbout RBT-4102 Installation Guide

Table of Contents

Other manuals for Enterasys RoamAbout RBT-4102

Questions and Answers:

Enterasys RoamAbout RBT-4102 Specifications

Related product manuals