Using the CLI
3-5
5. Specify the management VLAN ID for the access point:
The management VLAN is for managing the access point. For example, the
access point allows traffic that is tagged with the specified VLAN to manage the
access point via remote management, SSH, SNMP, Telnet, and so forth. VLAN
management is enabled by default, and cannot be disabled.
Note: You must set up the network switch port to support tagged VLAN packets from
the access point. The switch port must also be configured to accept the access
point’s management VLAN ID and native VLAN IDs.
6. Refer to the RoamAbout RBT-4102 Wireless Access Point Configuration Guide
for advanced configuration.
RoamAbout 4102(config)#management-vlanid 10
Reboot system now? <y/n>:y
Username: admin
Password:********
To Next Page
Loading...
