Need help?Do you have a question about the Entes RGI-12SW and is the answer not in the manual?
General| Model | RGI-12SW |
|---|---|
| Frequency | 50/60 Hz |
| Output Voltage | 250 VAC |
| Communication | RS-485 |
| Operating Temperature | -10°C to +55°C |
| Relay Output | 12 |
| Protection Class | IP30 |
| Digital Input | 12 inputs |
Details the general specifications of the RGI series reactive power factor controller.
Describes how to access and view power factor correction values for the current month.
Guides through the initial setup process, including language and configuration screens.
Details accessing and navigating the Settings menu for product configuration.
Enables changes to frequency, CT values, and step settings.
Performs connection correction to ensure proper operation and auto setup.
Sets primary and secondary values for accurate current measurement.
Allows setting the system's nominal frequency (50 Hz or 60 Hz).
Performs automatic step recognition and configuration for the product.
Configures used steps, step type, connection, and total step power.
Selects the power factor correction program (Linear, Capacitor/Reactor, Combination).
Chooses the power factor correction mode: Eco, Sensitive, or Standard.
Sets the desired power factor (CosФ) value for the system.
Configures Modbus RTU settings: address, bit rate, and parity.
Configures and manages alarms and warnings for the system.
Triggers an alarm when the inductive power factor rate exceeds a set threshold.
Triggers an alarm when the capacitive power factor correction rate exceeds a set threshold.
Sets voltage alarms with high threshold, hysteresis, and optional step protection.
Configures alarms for Total Harmonic Distortion of Voltage (THDV) with protection.
Configures alarms for Total Harmonic Distortion of Current (THDI) with protection.
Sets high and low temperature alarms, with optional step protection.
Provides options to reset product settings or energy counters.
Resets the product to its original factory settings.
Provides detailed information on current and voltage harmonics.
Allows viewing current harmonics from the 1st to the 31st harmonic.
Allows viewing voltage harmonics from the 1st to the 31st harmonic.
Displays the Current Total Harmonic Distortion (THDI) values.
Displays the Voltage Total Harmonic Distortion (THDV) values.
To Next Page
