Entrematic Ditec HA8 LP - Default Chapter; Table of Contents

Entrematic Canada Inc.
Toll Free: 1-877-348-6837
info.ditec.ca@entrematic.com
www.ditecentrematic.ca
Entrematic USA Inc.
Toll Free: 1-866-901-4284
info.ditec.us@entrematic.com
www.ditecentrematic.us
Pg. 3
HA8-LP Manual V. 4.0
Table of Contents
1.1 Replacement Parts
1.2 General Information
1.3 Technical Specifications & Required Tools
1.4 Door Handings
1.5 Consideration of Surroundings
1.6 Electrical
2.1 Pre-Mounting Header Box Instructions
2.2 Operator Layout and Handing - Push and Pull
2.3 Handing Modification - Left to Right (and vice versa)
2.4 Double Egress Header
2.5 Control Board and Gearbox Installation
2.6 Connect Motor Wire Leads
3.1 Arm Components and Configurations
3.2 Push Arm Installation
3.3 Pull Arm (Z-arm) Installation
3.4 Universal Arm Installation
4.1 Back Check and Latch Adjustment
4.2 Spring Tension Adjustment
6.1 Basic Operation
6.2 Operation Switch
7.1 Digital Board Diagram
7.2 Digital Board Wiring Diagram
7.3 Digital Board Specification
8.1 Programming Specification (Digital Board)
8.2 Safety Monitoring
8.3 Safety Sensor Connection - BEA Bodyguard
8.4 Safety Sensor Connection - BEA Superscan
8.5 Safety Sensor Connection - Optex OA-FLEX
9.1 Dual Door Digital Board Specification
(Fully Automatic only)
9.2 Wiring Diagram
9.3 Programming Specification
12.1 Additional Components:
Sensor(s) / Knowing Act Devices
12.2 Header Cover Installation
12.3 Safety Decals
13.0 MANUFACTURER INFORMATION 60
6.0 DOOR OPERATING MODE 38
5.0 TESTING WITH OBSTRUCTION 37
4.0 OPERATOR TUNING 33
3.0 ARM INSTALLATION 22
2.0 OPERATOR INSTALLATION 11
1.0 BEFORE INSTALLATION 4
7.0 CONTROL BOARD SETTING 39
8.0 CONTROL BOARD PROGRAMMING 42
9.0 DUAL BOARD & PROGRAMMING 50
10.0 TROUBLESHOOTING 55
11.0 ADA ADJUSTMENTS 56
12.0 INSTALLATION WRAP UP 57