Enviro C34 - Installation - Side Vent Setup; Side Vent Setup

14
Installation
QUALIFIED INSTALLERS ONLY
side vent:
Prior to installing your Cool Surface System Side Vents you will need to set up your Side Vents in the
conguration required for your instalation. A T20 screwdriver is required for assembly and dissaembly.
Step 1: Pop off your front bezel from the side vent. Its retained by clips on both sides.
Step 2: Remove the the grill by removing the 4 T20 screws.
Step 3: Remove the duct collar register.
Step 4: Attach your 5” ex vent to the duct collar register using self tapping screws.
Step 5: Adjust your side vent to your facing
material depth. The side vent trim surround
can be adjusted to account for 1/2”, 3/4” or 1”
material thickness.
Figure 19. CSS Side Vent Set-Up
Figure 20. CSS Side Vent Depth Adjustment
1/2” Facing
Material
1” Facing
Material