Enviro C34 User Manual

1
INSTRUCTION MANUAL
This Cool Surface System has been tested for compliance to Standards:
ANSI Z21.88-2014 and CSA Z2.33-2014.
This Cool Surface System has been approved for use on the ENVIRO C34/44/60 Direct Vent
replaces only and must be installed at the time of replace installation.
The following instructions must be followed in conjunction with the replace installation
instructions to comply with the standards and allow safe operation of the installed replace.
Version Française: www.enviro.com/fr.html
4001609
Cool Surface System
SIDE VENT [50-3455]
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
C Series
50-3455

Enviro C34 Specifications

General

Category	Fireplace Accessories
Model	Enviro C34
Fuel Type	Wood Pellets
Ignition	Automatic
BTU Output	34, 000 BTU
Heating Capacity	Up to 2, 000 sq ft

Summary

General Information

Dimensions

Framing & Clearances

Front Framing & Rough Opening

Details minimum framing and rough opening dimensions for C-Series fireplaces.

Horizontal Installation Clearances

Minimum Clearances - Horizontal Installation - Minimum Vent

Specifies minimum framing and clearances for horizontal vent installations of the CSS.

Vertical Vent Clearances

Minimum Clearances - Vertical Vent - Minimum Vent

Specifies minimum framing and clearances for vertical vent installations of the CSS.

Initial Installation

Revised Mantel Requirements

Outlines revised requirements for installing combustible mantels with the fireplace.

Installation - TV Considerations

TV Installation Considerations

Provides guidance on safely mounting a TV above the fireplace, considering heat protection.

Installation - Duct Collars & Facing Kit

Duct Collars

Instructions for attaching the supplied duct collars to the top of the fireplace.

Combustible Facing Kit (Optional)

Details on installing the optional combustible facing kit, including deflector trimming.

Installation - Side Vent Setup

Side Vent Setup

Steps for setting up the Cool Surface System Side Vents for installation.

Replacement Parts

Notes