Enviro C34 - Vertical Vent Clearances; Minimum Clearances - Vertical Vent - Minimum Vent

6
Framing & Clearances
QUALIFIED INSTALLERS ONLY
Min. Distance to
wall 5.00” (13cm)
Min. Ceiling
Height
18.75”
(48cm)
*15.75” (40cm)
11.5” (29cm)
Min. Dist
61.75”
(157cm)
*NOTE: 15.75” from the
header is required for min.
ceiling height. Rest unit on
lower standoff. There will be
a 3/4“ (2cm) gap on from
the top standoff to the
header in this confirguration.
Min Framing is 15” x 11.5”
3/4” (2cm)
Gap Shown
Min. Distance
to Ceiling
4.5” (11.5cm)
Min. Distance
to oor
64” (162.5cm)
minimum ClearanCes - vertiCal vent - minimum vent:
The CSS has been designed to allow for installations where a vertical run of vent is required without
having to jog the vent pipe around the CSS. The horizontal vent shield supplied with the replace is not
required (see Owner’s Manual) when vertically venting and the vent pipe can simply be run straight up
between the side vents of the CSS.
Shown below in Figure 6 are the minimum framing and clearances for the CSS with the vents installed
vertically and when the replace is installed with the minimum allowable vent length:
Figure 6. CSS Horizontal Vent - Min. Framing & Clearances
Min. Vent
39” (99 cm) Min.
Length 5” dia.
ex vent
(not supplied)